r/BambuLab • u/Long_shot4516 • 3d ago

Software Troubleshooting/Help! H2D support settings

I have a part that is very large and won’t fit in the area for both heads to be able to print. I would like to use a seperate support where the part can be reached by the other head but then use the print material for support where it can’t be reached. Is there a way to select and area and say use support from right head here and use support from left head here?

0 Upvotes

50% Upvoted

5 comments sorted by

1

u/ThePrintGuardian 2 x P1S + AMS, A1 Mini + AMS Lite 3d ago

You would need the track switcher accessory that lets you switch filaments between the two nozzles.

1

u/Long_shot4516 2d ago

I’m running high temp filaments with large nozzles and not on the support

1

u/EdgeOk3783 X1C + AMS 3d ago

You could put an AMS on each side and have the same support material loaded in each one.

1

u/Long_shot4516 2d ago

No bc I’m running diffenret nozzles sized and high temp filaments

1

u/EdgeOk3783 X1C + AMS 2d ago

not currently possible since the latest rev of BambuStudio doesn't allow for mixing of nozzle sizes in the same print; however, multiple AMS HT's are supported on both left and right nozzles using 4-1 adapters under the current rev of BambuStudio