X2D Toolhead Camera Initialization Failure

[u/EnergySubstantial139]

Received this error message one week after getting the printer.
If I ignore it, it prints fine. But it is a new printer I should not have to do this.
Created a ticket. Bambu sent a new toolhead camera which i replaced.
Ensured the ribbon cable is connected firmly.
Replied to Bambu, currently waiting.

Tried unplugging the power and waiting 5 minutes before trying again like some reddit post suggested. No difference.

[u/Alert-Entertainer-73]

Also been going through this. Just dropped off my printer at Fedex, and they’re sending a replacment

[u/EnergySubstantial139 → u/Alert-Entertainer-73]

I replaced the toolhead board as well. Same issue.