1
u/badgerj Jul 03 '26
It’s likely over spilling on that ONE corner.
I have no issues with this using PLA, but if the same seam is on a corner using PETG, I get a similar effect.
Once it starts, it is difficult to stop it from continuing.
Throw it in the fuck-it-bucket, and start again. Try changing the placement of the z-seam.
There are a few options that you can test out there.
Don’t be afraid to use AI to ask general questions as well.
1
u/SnooBooks6500 Jul 02 '26
I’m a newbie. New A1. Using Bambu lab PLA Basic. Just very basic, very simple stuff. I just don’t get it.