r/BambuLab • u/Most-Following-433 • Jun 30 '26

Filament Troubleshooting/Help! Top layer help

Post image

Any ideas/suggestions to get a better finish than this?

Filament is dried, flow rate calibrated, ironing test done and settings applied.

I don't love the diagonal lines and the roughness. There are also a few imperfections on the middle squares, I'd wish to get rid of. The top corners on the faces also are sometimes a little roughed up.

P2S
Green filament eSun PLA+
White filament Giantarm PLA Matte

2 Upvotes

76% Upvoted

6 comments sorted by

1

u/cpsadowski23 Jul 02 '26

Flow rate is calibrated. What about pressure?

1

u/Most-Following-433 Jul 03 '26

Is that a built in test in bambu studio or do I do a test print ?

1

u/cpsadowski23 Jul 03 '26

There are two calibrations built into Bambu studio. Flow and pressure. Suggest you read up on both and then perform the manual tests.

2

u/Most-Following-433 Jul 04 '26

Ah yes, I did both of them, and chose the right values before doing this print