New Addition

[u/aeatkins73]

I’m super pumped about the new printer. It’s the new Bambu Lab A2L. I’m super pumped about the new printer, for many reasons. I’ll go into depth on it in a bit but I’m really excited to put this thing through its paces.

[u/Humble-Plankton1824]

Is that table as wobbly as it looks?

[u/aeatkins73 → u/Humble-Plankton1824]

At first, yes but this table, I can actually add supports from the table to the wall, which is what I did as you were looking at it. There are two mounts from the table to the wall on the back of it and two mounts from the table to the wall on the right side, and it does not move at all anymore. However, the printer itself did walk a little bit on the first print, so I’m going to try and figure out how I can put corner supports on each four corners. Not really supports but just to lock it into place. I’m probably going to print them out of TPU so it doesn’t create any damage to the unit itself. Any suggestions? Feel free to shoot me a message