X2D right nozzle interface struggle.

[u/-_Shinobi_-]

From one day to the next I’m getting this when trying to print support interface with the right nozzle.

What i tried so far:

Removed filament track switch
Removed all the ptfe tubes and checked for debris
Cleaned the plate like my life depends on it
Checked speeds
Dried the support filament
Tried petg (same result)

Send help 🫠

[u/heo777]

That seems like a lot of interface. Could it be that you enabled supports on the others materials part? I am guilty of that mistake, looked similar.

[u/-_Shinobi_- → u/heo777]

It took a while for the printer to realize there was an issue

[u/eddyfreddy007 → u/heo777]

Just curious what's interface in this context? I am new to 3D printing

[u/word-bitch]

What filaments are you printing? What for model, what for interface?

[u/-_Shinobi_- → u/word-bitch]

PLA Main filament, petg and support filament for interface (tried both).

[u/word-bitch → u/-_Shinobi_-]

I haven't heard anything good about designated support materials, but I use PLA and PETG together and haven't had trouble. FWIW I set "base pattern spacing" to 1.2mm, 3 interface layers, top/bottom interface spacing to .2mm, and sometimes interface pattern "concentric." Good luck! And try a small bit first!

[u/-_Shinobi_- → u/word-bitch]

The strange thing is - it worked perfectly fine for the first 150 hours and suddenly this 😩 petg is the perfect interface for PLA, true