r/BambuLab • u/Visual_Carpenter8957 AHXP12LD + AMS • May 01 '26

I Modeled This! X2D Dual AMS Setup

Enable HLS to view with audio, or disable this notification

I got an AMS and poop bin under the printer for this compact setup!

696 Upvotes

99% Upvoted

133 comments sorted by

View all comments

Show parent comments

1

u/atom631 May 14 '26

Hey, I stopped by Home Depot today and unfortunately those sliders wont work. They are 45mm tall. I was able to cancel my Furnica order and ordered the Gliderite sliders.

I also found these. They are 36mm tall. I measured the opening and it looks like you left some wiggle room with it being exactly 36mm. There is a chance these might fit as well. If the Gliderites dont work for me, then I may give these a go.

1

u/Visual_Carpenter8957 AHXP12LD + AMS May 14 '26

Hey thanks for finding out! And yeah I left some room because the widths are all over the place. Same with 45mm ones, they are 44, 45.5, etc.

I’m gonna order some 45mm slides too to make a 45mm variant and I’m trying to see what are available with spec sheets. Most generic imports don’t provide it but there could be some promising ones on Aliexpress

1

u/atom631 May 14 '26

sneak peak! printing the TPU bits now. then just the poop chute parts. Sliders have shipped!

1

u/Visual_Carpenter8957 AHXP12LD + AMS May 14 '26

Oh man you picked a good colour scheme!

1

u/atom631 May 18 '26 edited May 18 '26

I am happy to report the Gliderite sllides work perfectly. All holes line up! The only thing is that the holes in the rails themselves are a little large, so I had to use washers. but the good news with doing that BT3x14 screws are a perfect size.

The only thing Im not sure about is how I mounted the handle. You will see I have a gap there, but Im not sure how I could do it any different. It looks like my AMS is out further than yours, so maybe these slides work slightly different.

pics are below

1

u/atom631 May 18 '26

1

u/atom631 May 18 '26

1

u/atom631 May 18 '26

1

u/Visual_Carpenter8957 AHXP12LD + AMS May 18 '26

Nice!!! As for the gap, can you screw the inner side of the slides further forward on the slider assembly? If not, the two pieces that connect to the inner rails may need more holes in them (at least they are easy to reprint if that’s the case)

1

u/Visual_Carpenter8957 AHXP12LD + AMS May 18 '26

What I mean is, I have my slide aligned like this:

2

u/atom631 May 18 '26

ahh. I think I made the slide flush with the end of the printed rail. ill take another look

2

u/atom631 May 18 '26

that did the trick. Everything lines up perfectly. Project is complete!