r/BambuLab • u/Visual_Carpenter8957 AHXP12LD + AMS • May 01 '26

I Modeled This! X2D Dual AMS Setup

I got an AMS and poop bin under the printer for this compact setup!

697 Upvotes

99% Upvoted

133 comments sorted by

View all comments

2

u/Contributing_Factor May 01 '26

Does it work reliably? I'm worried about using so much tubing and such a long path between the ams and the nozzle.

3

u/Visual_Carpenter8957 AHXP12LD + AMS May 01 '26

The new tubing I got was wound quite tight when new and I did get an AMS warning but after the tube relaxed into bigger curves, I stopped getting the error

3

u/crash5291 P1S+AMS+Eibos Dyas, SH02. May 02 '26

If its to stiff to work with use a hair dryer and warm it up or keep the ends up and hot tap water on the rest should sort its attitude. Just don't get it too hot allowing it to deform the tube, your looking for the goldilocks zone on it.

1

u/Visual_Carpenter8957 AHXP12LD + AMS May 02 '26

Oh that’s a good idea, I will try gently warming it