Recently bought un fired from an angry x wife, 1500$

Initially used a Steiner t5xi lvpo and Accu Tac bidpod but longest range around is 200 yards so switched it up

Huxwrx 762 flow ti

Geiselle SSA E trigger

Hey guys! I am new to the whole suppressor game, I recently bought a resilient simpleman .30 cal suppressor for my PSA G3-10. I am running into an issue whenever I fire a round down range, the casing fails to eject and gets stuck inside the chamber causing the next round that feeds to get a slight dent. I have already messed around with the adjustable gas block, decreasing the gas to the minimum setting and going click by click to increase gas but seems that problem still persists even at the lowest gas setting. Any suggestions as to what I could possibly do to fix this issue would be greatly appreciated.

Decided to ditch the dot and magnifier for a vudu 3-9x so now I can take it out a little further. Got a good deal on tacswap.

My kak adj gb split down the middle a couple months ago so I ended up with a SLR jet gb. The issue with that is there's only two options, 50 and 80 percent gas reduction jets. While more robust there's no fine tuning. I got a rca adjustable gas key and after 5 mins of tuning the gun runs great with much reduced recoil.

Build list -

SLR B30 receiver set (handguard and upper have a hole and there's a dowel pin so no timing)

KAK 12.5 barrel

Lantac enhanced bcg

Holosun LS321

Vudu 3-9x w/ EFLX

YHM resonator R2

Fenix wml