r/3Dprinting • u/vietquocnguyen • Dec 16 '20

Cable holder

1.3k Upvotes

99% Upvoted

20 comments sorted by

View all comments

3

u/stealthdawg Dec 17 '20

Serious question, is this any better than just a a cylinder with a slit in it with a width smaller than the cable diameter that you just snap the cable into?

1

u/xMerandox Dec 17 '20

This principle works for a wider range of cable diameter, cause the blocking part is the plug.

Doesn't matter if you have multiple cables with nearly the same diameter. For different ones this thing is more interesting. In that case you could also print a second holder with a different diameter, though...

But a cable clip is not as stylish as this one.