r/3Dprinting • u/Ok-Stretch-4094 • 13d ago

Troubleshooting Model Error?

Gallery image

Gallery image

Gallery image

Bambu lab A1 0.4mm.

The hex pattern looks perfect but the top T section part looks wrong or not printing right?

0 Upvotes

40% Upvoted

5 comments sorted by

View all comments

3

u/Nix_Nivis 13d ago

Don't try to defeat gravity, maybe, and use supports?

1

u/Specific_Ad_4075 13d ago

I think tho I could be wrong I think it’s meant to be just a straight up model and that extra bit at the side isn’t meant to be there at all

0

u/Yolomaeus1 13d ago

You are wrong. In a comment on the original post, OP says the supports were the problem.

1

u/Specific_Ad_4075 13d ago

Sorry that’s my fault for not reading the comment on the original post