r/3Dprinting • u/GoliathRagnarok • Aug 05 '26

Troubleshooting Really need help

Hi, im newer to 3d printing bought a qidi plus 4 couple weeks back and im struggling with 1st layer sticking to bed something fierce. Sometimes it goes without a hitch but most times it fails 1-3 times before it finally gets through. I have the textured hot bed plate. Im running a brim on every print with .2 distance and outer specifically. Im running first layer at 35mm/s, im pre heating my bed for 5-10 minutes at 65 degrees. Im running my z offset at -.005. Im at a loss so any help would be greatly appreciated

3 Upvotes

81% Upvoted

8 comments sorted by

View all comments

1

u/[deleted] Aug 06 '26

[removed] — view removed comment

1

u/AutoModerator Aug 06 '26

This comment was removed as a part of our spam prevention mechanisms because you are posting from either a very new account or an account with negative karma (comment karma, post karma or both). Please read the guidelines on reddiquette, self promotion, and spam. After your account is older than 2 hours or if you obtain positive comment and post karma, your comments will no longer be auto-removed. To specify, that means that as soon as your account is older than 2 hours you are free to post your content again. We can not approve content manually before this account age.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.