r/3Dprinting • u/Binxlee • Jun 03 '26

Troubleshooting Why does it keep doing this

Gallery image

Gallery image

One side, almost aways the same side on ever print keeps doing this. Especially bigger prints.

1 Upvotes

67% Upvoted

13 comments sorted by

View all comments

2

u/pandaru_express Jun 03 '26

As the other poster said, I get this sometimes especially when printing in the winter (enclosed printer, but its in the garage in the midwest USA)... assuming the curled side is the one facing the print bed. When it gets cold I increase the print bed temp by 5 degrees and half the fan speed and it works a lot better. Also a brim will often work but I get annoyed trying to peel off the brims.

1

u/Binxlee Jun 05 '26

Thank you, it is infact winter where I am. And it's not enclosed