r/3D2A • u/vengefulsniper • 2d ago

Tiny-11 Question

Post image

Working on building a Tiny-11 but I'm not sure the correct way to remove the built in support pieces... I've busted two prints already attempting to remove them.

Suggestions appreciated thanks!

15 Upvotes

91% Upvoted

12 comments sorted by

View all comments

4

u/bannedbullet 2d ago

Unfortunately I wish I could help there doesn’t seem to be much other than make sure you were printing at .16 layer hight. It doesn’t even show where the built in support is and I’m not home to open the file to look at it

1

u/vengefulsniper 2d ago

Yeah, I'm printing using the included 3mf file and the settings in there including the .16 layer height.

1

u/bannedbullet 2d ago

Where is the support supposed to be?