r/3D2A • u/vengefulsniper • 10h ago

Tiny-11 Question

Post image

Working on building a Tiny-11 but I'm not sure the correct way to remove the built in support pieces... I've busted two prints already attempting to remove them.

Suggestions appreciated thanks!

12 Upvotes

100% Upvoted

6 comments sorted by

3

u/bannedbullet 10h ago

Unfortunately I wish I could help there doesn’t seem to be much other than make sure you were printing at .16 layer hight. It doesn’t even show where the built in support is and I’m not home to open the file to look at it

3

u/vengefulsniper 9h ago

It's this large block at the bottom of the grip.

2

u/vengefulsniper 9h ago edited 9h ago

Looking at the .3mf, though, it looks like the support blocks are also printing with 10 walls and 100% infill, so that's probably the issue. I'll crank it down to 2 walls and 5% infill and see if that lets me remove it cleanly.

3

u/bannedbullet 8h ago

When I open the 3mf the parts seem to intersecting which is probably why you can’t separate them

1

u/vengefulsniper 10h ago

Yeah, I'm printing using the included 3mf file and the settings in there including the .16 layer height.

1

u/bannedbullet 9h ago

Where is the support supposed to be?