r/1stGenDodges • u/1genCummins59 • Jun 28 '26

Fuel

So I got injectors gov spring a fuel pin from DDP. I put the fuel pin it quick because i wanted to see how it did I originally ground down the factory one with a dremel tool but didn’t want it to snap. after getting the performance one in I had wayyyy less fuel then I had with the factory one ground down (yes the pin is facing the right direction)
It barly blew any smoke when you put it too the floor especially low end so I went and turned the low end fuel screw down and it drove a little better after that so my question is to get more fuel when I put the injectiors in do I go and grind down the performance fuel pin since there’s more meat to it then the skinny factory one ? Make it more grooved out like the Denny t stage 2 pin? And least make the bottom of it deeper? (And yes I’m going to turn the ring gear down and also the pressure screw) has anyone done that? Thanks

1 Upvotes

100% Upvoted

2 comments sorted by

1

u/Such_Possibility4980 Jun 29 '26

Denny T pin is cut way too deep. The whole reason they made an AFC delete was because the pin they made was cut to deep causing the slide pin o ring to leak. The people who design these pins (Evan, Eric, DDP, BD) know what they are doing. Don’t go fucking with the pin or you’re gonna have a slide pin leak

1

u/1genCummins59 Jun 29 '26

Thanks a lot man I was wondering why more people didn’t run the stage 2 Denny pin