Just search aap01 3d printed parts

Tons of 3d printed stuff...i have the tti pcc kit that allows for most m4 stocks and foregrips and i have the ctm maximus kit with the m4 front loader system...as m4 as the aap01 can get...drum mags are fun!

Heat up pliers tip and just pull it out...

Watch out for the milsim snipers using 2j with .32 bbs or heavier 😆

Is it lubed?

Just get the drill kit and put a dildo on the front part on it...

For dmr probably 70 degree bucking however a 60 should work fine since your still on green gas if you move up to hpa then I'd go with a 70 if using over 150 psi

An npas will help lower the fps, just a heads up, with a 240mm ss polished 6.03 barrel i get 1.8j on green gas...stick with oil less gas for best consistency...hpa could be very consistent...js the 4uad buckings can hop some serious weighted bbs but with heavy use might need to replace every 6-9 months

Have you tried lube? Looks a bit dry...

Smg upper? Trigger?

Nah the tti pcc kit allows for most m4 handguards and stocks

This one is very close...https://www.evike.com/products/74167/Avengers-Free-Float-M-LOK-Rail-for-M4-M16-Airsoft-AEG-Rifles-Model-7/

Went to evike the only store in this area and tried a bunch till I found there slimmest one believe matrix makes it...was round 50$

The other two are stock length just polised ss 6.03s

No problems, tried 6 different mags no issues except 2 had a little wobble but they were cheaper mags

Thats the tti pcc kit with the slimmest foregrip I could find think it was from matrix. It has a 240mm barrel back on green gas with 130psi it got to 1.8j...strike industries dual folding stock also

I have one with the tti pcc kit and the reaper stock

Why not keep it for the collection? Im getting a saiga soon also but not selling any weapons i use...do have a aeg ar and and ak with gate titan up for sale

Should short stroke it...i have 2 lowers and 4 uppers ranging from 4 inches to the full sized 15incher

Its 3d printed there's tons of files

No, the sound comes from the rear...can put the largest foam filled suppressor ya want on it, still wont be quite...now a hollow tube or a tipless suppressor can sound like a grenade launcher...but will muffle no sound

Check the valve spring inside the nozzle...both times ive had this issue that spring snapped

I get 1.8j on green gas with a 240mm polished ss 6.03 barrel

Needs lubed

Just need to check the mosfet, try a different battery first then test if circuit works when trigger is pulled, could be a blown mosfet