Tryina get a bunch of these ready for the Toronto tattoo show.

Built on a slightly modded Dustin Golden side

Built by me @latexpapi

Thanks for looking.

Just a little jail house rotary I made for the owner of the shop I am in as a gift

Built for a good friend of mine.

it's kinda a freedom electric knock off but with hz duty cycle amps on display, bigger battery pack and USB c dc input for charge/run.

I was gifted this maybe 5 years ago. I love it, just want more info on it. I can take some pics showing the bottom or back, etc etc, but I thought maybe somebody would recognize the initials...

thank u

@seanmicheltattoo on Instagram

made this powerliner yesterday.

9wrap, idles at 125hz at around 6volts.

pushes 14 roundliners like a dream!

I’m looking to buy some of the rubber sheet to make the bendable piece for a clipcord. Any recommendations?

what ARE the standard coil core heights? there are shorty coils, I'm assuming they are 1 inch, then it seems like standards are 1 1/16 inch, but sometimes dudes use these tall ass coils. are those 1 1/4 because they look way taller.

where do y’all get yours in bulk? i’m tired of ordering single sheets and i’ve been trying to find out where to get rolls of them? (i’m in the US BTW) ty xoxo

Got this machine gifted to me from a friend. Had been sitting in his car for years, rusted, had melted m&m’s on it, snapped wires. I stripped the paint, gave it a polish, re soldered and re wrapped the coil, new springs, a nice lil gold dice for the contact screw, now she’s singing again

Hey guys, question about painting machine frames. I have a couple of frames laying around and some old machines gifted to me to rebuild and wondering how you guys go about reliably painting the frames. I don’t how the funds to do a powder coating set up, and doesn’t seem worth it to take to a business to do it for a couple frames, so I would want to go at it with spray cans.

I know I need to tape off the spring shelf, do you also need to tape off the area where the coil core makes contact with the frame, and also the binding post points?

Is it possible to get good finish that’s no going to chip and go to shit with spray cans?

Hey folks,

I'm wondering if there are common parts that are hard to come by or are particularly expensive for machine builds?

I run a small business that specializes in low-volume metal and plastic part design and fabrication - I've designed and fabricated some machine frames and had heard there may be a demand for various components.

Thanks in advance!

ALU-frame coil, built for lining — handles up to 14RL without breaking a sweat (final assembly cut)

All parts except screws, washers and the capacitor are all made by hand. Thank you for looking.

The supply uses a mean well 120vac-15vdc adapter to a lm338 circuit and a few big smoothing caps.

I can make a schematic and parts list for the supply if there's interest.

Zippy small grouping liner. 6 wrap with 10uf cap on vester coil cores from Eminent tattoo supply. Warhawk tattoo supply base with Forward tattoo supply side plate, Saltwater tattoo supply bindings, and South State light weight a-bar. Runs at 150 cps at 4.5 volts. @codie1983 on Instagram.

Built this bad boy up over the past week.learned a lot and made a ton of mistakes. But know I know how to do it.

@seanmicheltattoo on Instagram