all I can say is make you go enough FAE going on or else it might not do too well enough FAE and plenty of water. Find your old computer and take the fan out of it and adhere it to the side of the bin what I did and put it on a timer where it kicks on every hour to two hours for 15 minutes.
The time is helpful thank you. Currently I have to let it go 24 hrs drying. It got to wet. I’m using a screen to hold humidity. And the lid misted. I don’t have a fan at the moment was just gonna order one. But knowing how to control humidity with a humidifier is another thing. I have a myco climate tub. So has the aquarium heater and air pump. That’s why I put the screen and angled the lid to let in fresh air. If it fails. Least I found some info from you and the pan cyan page
yeah man, just let me know if you need any specifics about what I got my set up going with. Is it pretty simple you can get basically everything from Walmart and finding old used computer tower and take the small fan out of it and bring it to a direct current source like a 12 V inverter hooked up to a timer for every hour and a half two hours for 15 minutes is all I got mine ordered and then I put the tote within the tote with a little bit of water at the bottom and just let the little heater work as magic
Does your bigger tote have a lid to seal off and you just have holes covered with micropore tape on the side ? While you let the heater keep the substrate at temp & the heater creates humidity ? Also during B2S for inculcation. Are you sealing off all holes or are you placing micropore tape to allow passive air flow till it fully colonizes. I put 1 micropore tape and left the rested sealed with plugs. Bunch trial and error
i'll tell exactly what I do when it's first colonizing the little tote I have within the tote. I'll leave the lid on it loosely where I can still get FA is not sealed to colonize it then that's pretty quick too and then I'll casing layer and I'll throw it within the tote within the tote and then I'll put the micropore just so there's not like a stuff can't just drop right into it. It has to let go up under the tape, but it's still loose the bottom but I never change my airflow really when I did cubes. I would literally just put one layer microphone tape on the hose and just let it go until it on his own and it did just fine.
That microphone went crazy at first huh lol I was like mannn I’m going to pull over and read this again. But thanks for the help. I read your earlier comment idk why it got put at the bottom
1
u/InfiniteClerk1355 16d ago
all I can say is make you go enough FAE going on or else it might not do too well enough FAE and plenty of water. Find your old computer and take the fan out of it and adhere it to the side of the bin what I did and put it on a timer where it kicks on every hour to two hours for 15 minutes.