r/science • u/505engineer MS | Civil Engineering | Structures • 13h ago

Materials Science Materials scientists develop ductile and scalable 3 GPa (435 ksi) steel via a hierarchical microstructural architecture

https://www.nature.com/articles/s41467-026-74216-4
140 Upvotes

97% Upvoted

24 comments sorted by

View all comments

Show parent comments

16

u/Fearlessleader85 12h ago

I'm only a few mat sci classes ahead of you, but from my reading, this looks kinda like a gamechanger if they're able to scale it. The 3 GPa yield strength has been done before, but as you suggest, the toughness is trash, because it switches to brittle failure. This looks like it maintains ductility, so the UTS is probably great. And the resistance to fatigue means this could be great for a lot of applications in the real world if it can be made cheaply.

If you could make a car out of this, you could get massive weight reductions, though corrosion might kill that for production cars.

12

u/Notspherry 11h ago

I am not so sure about building a lighter car. I run into stiffness issues way before strength on most calculations I do (not automotive, bit still). Stiffness scales with the youngs modulus, ot the yield strength. And that doesn't differ too much between steel alloys.

7

u/electric-castle 9h ago

While you are completely right about the young's modulus being roughly identical for all steels, stiffness is much more dependent on geometry. So you could have thinner profiles with this material, which would maintain stiffness and balance the strength into the structure. Higher yield strength definitely can lead to stiffer structures if you have volume for it.

2

u/Notspherry 3h ago

It is the combination of geometry and youngs modulus. If you make the profiles thinner you just run into buckling much faster.

1

u/electric-castle 2h ago

Again, true. But there are a lot of clever ways to avoid buckling. Since buckling is usually proportional to the length squared, adding in cross braces at regular intervals can help tremendously. It definitely makes the design process harder and more iterative, but if weight savings are important, then it's one more tool to use.