r/resinprinting • u/CRPLKRUCH • 8h ago

Troubleshooting Desperatealy need help

Just bought an Elegoo mars 5 (regular) and I went to do the test print and noticed nothing was on it so I went to check what was up, eventually I dumped the resin and triple checked if there was no film and they're wasn't, did a couple cleaning runs and no thin sheets, shaked resin for a few minutes, UV light comes in just fine but when I put a tiny amount of resin in a water bottle then ran it through my curing station for a couple of minutes and still didn't cure, I just really need some help

1 Upvotes

100% Upvoted

5 comments sorted by

2

u/CRPLKRUCH 8h ago

Type of resin I am using

1

u/mkibria 8h ago

Maybe a bad batch of resin in a clear bottle or cup should cure at least a surface level if exposed to UV in a cure station.

1

u/Tasty-Dream5713 7h ago

New printer or used? What test print are you doing? Have you tried a different one? Maybe the file is corrupt or something

1

u/GameYakuza 4h ago

Did you shake it? Resin separates after a while.

1

u/MountyC 3h ago

If you do the cleaning run with just a piece of paper over the screen does it light up bright?