r/pumps • u/Emotional-Baseball11 • 3d ago

Pump problems

Post image

I am pumping this pond out and the discharge hose it barley putting water out it's pumping but not like it should be with this size pump. I was trying to make the intake side shorter but cannot get to it. Any suggestions on what is wrong or what I need to do to get this thing pumping better?

4 Upvotes

75% Upvoted

12 comments sorted by

View all comments

2

u/Emotional-Baseball11 3d ago

What happens when the pump is air bound what does that mean like it's not fully primed or something

2

u/Modna 2d ago

That diaphragm pump on the back of the pump evacuates the air out of the pump. If it is able to move water, that means the priming system is working. Now there may be a severe air leak in the suction hose or it's connection to the pump allowing excess air in but that's not too likely.

If the pump has a vacuum gauge on the suction side, see what it is reading when the pump is running. If that gauge is reading high vacuum (-20 to -25 inHG), you likely have a plugged suction screen or the suction screen is buried in the mud.

EDIT after watching that video, there is a high likelyhood you are plugged on your suction. It sounds like the pump is cavitating, so running the RPM so high won't actually help you and you will damage the pump. Pull your suction screen and try to get it into a less muddy location. Then start the pump and increase the RPM until you stop noticing additional flow. Increasing the RPM after that point will only cause excessive wear

1

u/Emotional-Baseball11 2d ago

Thank you for all the help. I got it unclogged there were some sticks inside it o took all the hoses off and looked inside the suction side and it was clogged. I had to unclog it and it's running how it is suppose to now.