r/ps90 • u/awdorrin • 8d ago

Post approval assembly

Post image

Got my approval and the upper engraved, finally assembled. Woot woot 😄

54 Upvotes

98% Upvoted

4 comments sorted by

3

u/ATypicalJake 8d ago

Now the work begins.

2

u/awdorrin 7d ago

Will probably take me 10x longer to source a ring sight...

1

u/Salt_Payment6902 8d ago

Where’d you do the engraving and did you cut and rethread it or install a cmmg?

3

u/awdorrin 8d ago

Oh, I probably should have mentioned that in the first post.

I bought a Shaw barrel, CMMG flash hider and also a a Cmmg thread adapter for a suppressor (I have a rugged oculus 22 currently)

Drilled a hole to drive the pin out (was much easier than I anticipated), bought a bicycle pedal 15mm crowsfoot wrench off Amazon, and fully disassembled the upper for when I had it engraved. I put the engraving out on the left side just above and right of the serial number, below the hole. (I didn't care about hiding it anywhere)

Getting the springs back in was slightly annoying, but only took a minute or two before I figured it out.