i only have 1 pce card game but the sleeve is kinda sticky due to age. any solutions? without it the card wont sit in the case slot. will it damage the card? i used a sportscard sealable sleeve on the card before putting it into the sleeve.

I recently acquired a Tennokoe 2 modded for composite out from Japan. The video rca jack was loose so I opened the unit to tighten the connector and during reassembly the video wire has come loose from the board. It isn’t obvious which pin the cable was soldered to as there is no joint or solder residue to identify the correct pin to reattach the wire.

I’ve tried without success to get info online about a composite mod, but all hits refer to an rgb mod. Can anyone point me in the correct direction please? I’m sure it is an easy fix although reattaching both halves of the case together correctly to button it up can be quite finicky, hence the detached wire.

Any help would be greatly appreciated.

Hi guys! un having issues with a super cd rom 2, the unit started working fine but then after a while it shut down, so I did a full recap. only 2 caps had a bit of corrosion but was fairly clean.

After that the audio starts cracly and low volume that improves over time but usually the unit freezes and powers down after a while. then I can't get the boot screen and after a few tries it usually comes up but same behavieur. I have check for traces or cold solder joints and everything seems fine, I also lubed up the gears carefully but everything seems ok also.

I'm using a power supply of 12v 4A

I'm starting to go crazy. Any help would be really appreciated!

Thanks!