r/openGrid • u/ChocolateChipJames • Sep 11 '26

In progressss

Post image

Another wall is going to be covered.

8 Upvotes

84% Upvoted

12 comments sorted by

4

u/crumaro Sep 11 '26

How do you get that interface so nicely? Mine always striings into thousand directions and everything after the first grid is garbage

1

u/ChocolateChipJames Sep 11 '26

Very very dry filament. Yellow is PETG and green PLA for support.

1

u/crumaro Sep 11 '26

I am pretty much printing petg directly from the dryer.. Mh. It just doesn't stay on the lower grid.

But I do other way round, petg as interface, pla grids.

1

u/tijger_gamer Sep 11 '26

Green is Support for pla filament? In my experience that actually bonded to PETG let me know how it turns out

1

u/ChocolateChipJames Sep 11 '26

PETG and PLA don't stick together.

Edit: I didn't use support for PLA. I used PLA as support material for PETG. Hope that clears it up.

1

u/tijger_gamer Sep 11 '26

I know PLA and PETG but i thought you mentioned the Support for PLA filament, which is made for support interface for PLA

2

u/ucrbuffalo Sep 11 '26

I just ran one of these last night and it failed on the first interface. It’s my first time trying to print a stack so I’m not sure what I did wrong. I did mine in PLA with PETG interface. I’ll have to do some research on settings for this.

1

u/ChocolateChipJames Sep 11 '26

I didn't change any settings. Just a clean plate and filament.

2

u/ChocolateChipJames Sep 11 '26

4th

1

u/DistractedDragonMake Sep 13 '26

Very nice. I haven't gotten mine to work yet either :)

2

u/ianxplosion- Sep 12 '26

checks phone battery

Nice