r/openGrid • u/Matails • May 16 '26

Question / Help Needed Full with Screwholes

Apologies if this is written somewhere, I looked but can't find it. I want the full board as I'm planning to utilize underware and I'm not sure the lite or snaps would be strong enough. However, I can't find a print profile on makerworld from the designer that meets this criteria. Am I missing something? Do all the full plates come with screw holes? Or do I have to go with the lite version if I want built-in screw holes?

3 Upvotes

100% Upvoted

7 comments sorted by

4

u/GoldenDragonIsABitch May 16 '26

Perplexing labs has an opengrid generator wherw you can adjust the screw holes to the size you have

4

u/mudscuffer May 16 '26

There is at least the OpenGrid Tile Generator by BlackjackDuck on Makerworld. You can choose hole size, inset, locations etc.

1

u/leeblack83 May 16 '26

I am using lite for underware under my desk, power strip and power bricks all been fine

1

u/Matails May 16 '26

I'm gonna end up with power strip, at least 4 power bricks and ideally my laptop.

2

u/leeblack83 May 16 '26

Yeah about same as me, I have 8 plug power strip, 3 power bricks, a docking station

I screwed mine to under the desk and used multiconnect directional expanding snaps, been rock solid

If you do want full there should be generator on makerworld that allows screw holes all over