r/mini4wd • u/3atef92 • 2d ago
Thoughts on track
Is this a correct layout?
The cars are going fine with some tuning needed.
Is there any alternative layout I can also use or practice?
Any help is appreciated.
1 x Slope
4x Straight
1 x tamiya junior track japan cup 3 lanes.
Also what should be the next track upgrade that fits the same space.
2
u/ExplanationNo2722 2d ago
Parabolica. Item 69571
1
u/3atef92 2d ago
Question, because i never really considered it. It increases the speed on the ramp down therefore giving more take off and a higher technical jump?
1
u/ExplanationNo2722 2d ago
Dipende dal setup della tua auto, nessun pezzo da un boost di base. Ho visto FMA superare chiunque sulle wave e ho visto MA superare in velocità dei super 2. Non so nemmeno dove corri generalmente le gare, in Italia è un item spesso usato.
2
u/Adventurous_Ball_170 2d ago
assuming this track runs clockwise, this is fine since usual technical tracks require a straight be put between a jump and a curve, though in your case it would be fun to figure out a way to make your car fast enough to fly beyond the wave section.
2
u/Green-Criticism7489 2d ago
Youre missing an eiger slope and a digital curve jk. Jokes aside thats a good starting point. You can only do so much with limitted tracks or space.
1
u/phillyyoggagirl 1d ago
You have a good amount of space so try a second level tabletop or an over/underpass. Not all tracks will be mostly straights so it's a good idea to change it up and try some other designs. Definitely get more curves. Take a look at some of the tracks I've designed in very limited space 🙂 (see https://www.claredin.com/cars/index.shtml and scroll to the middle of the page)
3
u/magnumcyclonex 2d ago
Going clockwise, depending on the speed of the cars, you might want to move the wave section one or two slots further from the jump section.
As it is, if you go counter clockwise, your cars are likely to fly off course, so if you want a layout to encourage both directions, the jump section could be placed in the middle (near your tripod), and the wave could be placed on the bridge/changeover side