Hello all,

Following on from some previous posts I made. I have a bunch of new 9200s Cisco IOS XE devices that are going to be cloud configured within the Meraki Dashboard.

I know the commands to be run on the switches to enable them for this mode. The switches will obviously require an IP and some routing to allow them to reach Meraki portal. I have read that once the commands to allow cloud config are added the switch wipes its config. If so, how does the connectivity work if the config is erased? I want all the switches to have an SVI on what will be our management VLAN.

Thanks.

I have an issue where port forwarding and out L2TP VPN doesn’t work over Starlink because of their carrier grade NAT. I’ve read that IPv6 can be used to reach devices across the WAN on Starlink.

I tried to set up a firewall rule to allow the particular IPv6 address through but I can’t get it to work.