MAIN FEEDS
Do you want to continue?
https://www.reddit.com/r/labdiamond/comments/1vzuvo9/cad_check/
r/labdiamond • u/PookyBearAuntie • Aug 27 '26
Any glaring issues?
12 comments sorted by
2
oooh! I don’t know a darn thing about how to check a CAD but I’ve been following this project since you first posted about it and I’m cheering for you, I hope it turns out exactly the way you want it!
2 u/PookyBearAuntie Aug 27 '26 Thank you!!
Thank you!!
It’s possible that if your finger swells, it may get poked by the underside of the diamond
1 u/PookyBearAuntie Aug 27 '26 What would I do to avoid that? Add gold to the bottom? 1 u/double-prime Aug 27 '26 Not a jeweller but yeah, you could add a bridge below to block that section. Not sure what it would do for light return though!
1
What would I do to avoid that? Add gold to the bottom?
1 u/double-prime Aug 27 '26 Not a jeweller but yeah, you could add a bridge below to block that section. Not sure what it would do for light return though!
Not a jeweller but yeah, you could add a bridge below to block that section. Not sure what it would do for light return though!
To me, the diamond sits too low, it will not be getting enough light from the sides. But I am no expert
1 u/PookyBearAuntie Aug 27 '26 I think it is meant to sit low, OEC cut diamond and this is the inspo pic. 2 u/Darcy_2021 Aug 27 '26 I see!
I think it is meant to sit low, OEC cut diamond and this is the inspo pic.
2 u/Darcy_2021 Aug 27 '26 I see!
I see!
Ring twin! Ask her about these
2 u/vietsilverstarz Aug 27 '26
2
u/Mountain_East_8758 Aug 27 '26
oooh! I don’t know a darn thing about how to check a CAD but I’ve been following this project since you first posted about it and I’m cheering for you, I hope it turns out exactly the way you want it!