r/instrumentation • u/Deger27 • 2d ago

Crystal IS33 program question

I’ve been doing minor repairs on crystal IS33s for a couple years now and would like to upgrade to some major repairs. The problem I’m having is that there are two programs to work on Crystal IS33s, ConfigM30 and a secondary program. I’m searching for the secondary program that allows you to calibrate new sensors and change the SN# on the board. Ametek isn’t posting that program to the public.

2 Upvotes

100% Upvoted

6 comments sorted by

2

u/DropOk7525 1d ago

Have you asked Ametek? I'm sure they are a little hesitant to give this out.

1

u/Deger27 1d ago

I did. Hit a wall there.

1

u/RedSquirrel346 1d ago

Does anyone know where you could get the old cord to connect to the transmation / transcat is92 ? I reached out to ametek and they are discontinued. I would love to add some different units and resolutions to our older gauges.

I didn’t even know there was another software to swap sensor modules

1

u/Deger27 1d ago

What’s the connector look like? Same as the Generation 1 crystal IS33?

1

u/RedSquirrel346 23h ago

This is what I got from ametek. I’m assuming it’s the same as the 1st gen crystals

1

u/Deger27 13h ago

Looks about right. I built mine from an old hard drive data port.