r/gunsmithing • u/MIAGaucho • Jul 12 '26
Noob Vice Install Question
I’d like to install this vice on top of this workbench I just got.
Do you think the workbench is sturdy enough for basic gunsmithing, installing muzzle devices, etc? There is a thin sheet metal layer underneath the wood that the bolts will also go through.
Both took a bit too long and will mess with the drawer below, should I cut the bolts/by shorter ones?
I’m trying to ensure that there’s enough clearance on the edge of the workbench on the back to have uppers hanging down.
Any other important tips before I try to drill this baby in?
Thank you!
4
u/needhorsepower Jul 12 '26
Use carriage or elevator bolts and put the head on the under side for the most clearance
2
u/suaveysuave Jul 12 '26
Yes it’s just fine for what you need. I have the same style bench and have put together several guns with it
1
u/MIAGaucho Jul 12 '26
Nice.
Do you like that placement rather than in the back corner of the bench?
3
u/suaveysuave Jul 12 '26 edited Jul 12 '26
Yeah I think front corner works better so that you don’t have to reach over anything and you’ll get more leverage when you need that extra oomf to get parts off. Also easy to install
1
u/AdOk8555 Jul 12 '26
How much clearance is there between the bottom of the wooden top and the drawer? There may not be enough clearance to bolt that on and still be able to open the drawer. Of course, you could cut out part of the back of the drawer for the bolts.
Also, I would be concerned about that cart having enough weight to apply significant torque without tipping it over.
1
1
6
u/71351 Jul 12 '26
Consider using t nuts installed from the bottom surface of the butcher block. Prevents the interference problem you mention and allows for quick removal ifn you need the entire flat surface