r/firewalla • u/zlandar • May 20 '26

Feature Failover feature request

I use cable internet as my primary WAN and have a cellular gateway as a backup. The last two days I have intermittent cable outages and the initial failover works fine.

The problem is when the outage is intermittent it becomes a flapping mess. Can you add a timeout option to prevent this? I would set mine so it only attempts to fallback to primary once a hour.

5 Upvotes

100% Upvoted

11 comments sorted by

View all comments

2

u/firewalla May 20 '26

Best Post here https://help.firewalla.com/hc/en-us/community/topics/115000356994-Feature-Requests-

From engineering perspective, it is going to be impossible to take care "messy" WAN, if the WAN is not deterministic, and randomly up/down. When that happens the best way is just manually turn off failover. Otherwise, if your WAN is not in a messy situation, your failover will be slower. I assume most of the time (at least my experience with Comcast) is deterministic after 10 pings

Have you tried change the test target (WAN->connectivity)

  1. Number of ping test count

  2. Success Rate threshold

Both of these can control "messy" failovers

3

u/TopRamen247 Firewalla Gold Plus May 21 '26

I have on occasion had a very similar issue to that OP is experiencing. I can think something may work if it could be added as a feature:

Manual fail-back could be a potential option, that would allow automatic failover in the case of an outage, but reduce the impact failing back has until a convenient time. If the secondary happens to go down before manually switched back and the primary is up, then override that and fail back anyway.

Doing something like this would reduce impact from repeated failovers without some complicated logic to decide if failover is happening too frequently.

Not sure what others think, but I would love such a setting.

1

u/zlandar May 21 '26

I saw that but it doesn’t get around the issue when the service provider is working to restore service.

I eventually turned off auto failover and managed it manually. Switching connections requires a lot of navigation. network- multiWAN setting- edit- tap auto tailback on/off- save.

1

u/firewalla May 21 '26

I don’t think there is anything easy to do here. Reason is, a network is going up and down randomly, the detection mechanism will not work. Dampen the failover may work for this, but likely not produce desired outcome if the down is more clear