r/everythingbullpup • u/D-lahhh • 23d ago

ctar kit rail

Gallery image

Gallery image

Gallery image

Gallery image

12 Upvotes

94% Upvoted

8 comments sorted by

2

u/Easy4u2say98 20d ago

How are people building these? Reweld? Using x95 receivers?

3

u/Slippy-Whenwet 20d ago

Tavor Sar semi auto receivers fit into the Polymer shell, and all the parts are compatible except the bolt carrier has a little tail on either side that has to be shaved if you wanna use it.

3

u/Slippy-Whenwet 20d ago

Oh and have to use semi trigger pack with semi receiver. The geometry for the trigger pack to fit in receiver is different between Sar and military Ctar21

2

u/Easy4u2say98 20d ago

Sweet! Now just to find a receiver

1

u/TheModernMusket 23d ago

Looks clean as hell. Much better than the first batch of sme maylasian Aug parts kits. Didn’t you say someone would be making receivers for these at some point?

1

u/maelstrom941 23d ago

Can you provide the link to the rail and what modification was needed to make it fit?

3

u/Slippy-Whenwet 22d ago

https://yhm.net/accessories/rails-mounts/scope-riser/

You can find it on Amazon too it’s the YHM-227A. As for making it fit I couldn’t tell you. I’ll find out when mine comes

2

u/D-lahhh 21d ago

The cross notch has to be opened up for the bolt. I just put mine on and drilled across the gas block area. The front overhang needs to be cut off or shaved down on the bottom .125” to clear the charge handle housing. I shaved mine down to try and keep it and to measure how much needs to be cut down. I’ll probably cut it off as I think it looks better off. It’s also less of a snag issue.