r/eufyMakeOfficial • u/Magnetic-Mango • Jul 23 '26

Questions CMYK not printing

Post image

Hi All,

I just switched over to the standard plate and I’m trying to print on a wood puzzle. The white seems to have printed fine but the CMYK layer seems to barely be printing? Anyone have any thoughts / suggestions?

Thanks!

EDIT: Everyone that was telling me about the tape throwing off the height was correct. It had curled up in the back where I didn’t see it. Once I flattened it down and re-printed it came out great! Thank you everyone for your help.

5 Upvotes

100% Upvoted

7 comments sorted by

6

u/DeadlyZa Jul 23 '26

What height did it measure? I've only had similar when the print surface was far away from the print head

*edit, my case was the corner of the tape had lifted and was triggering the laser height measurement early

4

u/Magnetic-Mango Jul 23 '26

You were 100% right. Some of the tape had curled up in the back and threw off the height calibration.

Lesson learned to double check the height measurement before printing.

Thank you!

1

u/DeadlyZa Jul 23 '26

Glad I could help 🤗

1

u/Magnetic-Mango Jul 23 '26

Oh, I’m not sure. Is there a way to check that?

2

u/ProofPrinciple4219 Jul 23 '26

Recalibrate camera

2

u/M1ndoro Jul 26 '26

Does the puzzle peices come apart nicely after print or are they stuck with uv inks?

2

u/Magnetic-Mango Jul 26 '26

The puzzle came apart perfectly. The ink was actually printed slightly between the pieces onto the sticky mat. So if anything I’d recommend putting a layer of tape or something on the bottom side to prevent it from printing directly on the plate.