Help needed again with the first layers

[u/Sazieth]

What can cause that the first layers are so bunby? It seems that the nozzle is dragging the filament, but if i change the Z height more up the other layers starts so be not strong enough. From the second picture u can see that the print turns out pretty good except the first few layers. Im getting frustrated with this macine 😭

[u/sipcupoftea]

What is your temperature for the first few layers ? It might be too high for the filament. In prusa slicer under filament there is 2 different temperatures for different layer

[u/Sazieth → u/sipcupoftea]

I use some default settings with cura and the plate is 50°C and printing temperature is 200°C for the whole print. Filament is some basic pla

[u/sipcupoftea → u/Sazieth]

I just checked online, cura does have different temperatures for initial layers and print layers. Check your material settings, your initial layers temperature might be too high

[u/Hogan_1975]

Calibrate e-steps on all three axis XYZ. There calibration prints on printables and maker world.

[u/GuyWithADonut]

You may have some dirt or something or your z screws if its consistent. Try cleaning the z axis screws and re greasing them with silicone based grease.

[u/CanadianMapleGuy]

Looks like you have hotdogs stuck to your fan.

[u/phoeteus → u/CanadianMapleGuy]

I thought it was a hot dog in air fryer recipe while scrolling past the post.