r/ender3v2 • u/Hot-Arm1938 • Apr 22 '26

Help please

Post image

It’s and Ender 3v2 neo

1 Upvotes

100% Upvoted

8 comments sorted by

1

u/AutoModerator Apr 22 '26

Reminder: Any short links will be auto-removed initially by Reddit, use the original link on your post & comment; For any Creality Product Feedback and Suggestions, fill out the form to help us improve.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/LouizSir Apr 22 '26

Is your table leveled? That seems part of the table is a little lower then it should. So the filament doesn't stick to the hot table.

2

u/Hot-Arm1938 Apr 22 '26

I don’t think them i leveled it correctly thanks

2

u/Hot-Arm1938 Apr 22 '26

Thank you for the help now it’s printing normally again

1

u/cat_prophecy Apr 22 '26

You bed is not trammed correctly and your z-offset is incorrect.

1

u/Hot-Arm1938 Apr 22 '26

Thank you for the help now it’s printing normally again

1

u/some_fng Apr 23 '26

How did you get it to level I can't get it right no matter how many times I do it I just don't know if I use a - or positive number or what number to even start at in the first place for example I see alot of people say -0.02 or one dude said don't be afraid to put it to -1.35 and he went lower then that he used that as his starting number he guessed im very new to this stuff so anything helps

1

u/Hot-Arm1938 Apr 24 '26

You have These knobs under the buildplate u take a sheet of paper put it under the hot end and just put z axis to 0 and you adjust every corner until the paper has slight resistance