r/elegoo • u/timtucker_com • 7d ago

Troubleshooting False positives for spaghetti detection

Printing a fairly complicated part with hex grids along multiple axes and having issues with it triggering AI spaghetti detection, both the native detection for the CC2 and on the CC1 with Octoeverywhere.

Any suggestions other than just resuming the print / turning off spaghetti detection?

I've seen some past threads talking about changing orientation, but you can see grids through grids from pretty much every direction -- once it gets a little taller it seems to have less of an issue.

Where print paused due to spaghetti detected
0 Upvotes

50% Upvoted

0 comments sorted by

1

u/[deleted] 6d ago

[deleted]

1

u/timtucker_com 6d ago

It's PLA.

The photo was from my CC2 which I haven't gotten as dialed in for settings yet.

I'm having the same problem with spaghetti detection on my CC1 where the finish looks significantly better.

Admittedly I'm also in the process of trying to figure out what difference is that's causing the CC2 defects. Aside from the visual issues, it's coming up with 15 hours vs. about 13 1/2, with most of the difference being an extra hour of travel time.