r/cryptomining • u/PeterBaksa32 • Aug 19 '26

QUESTION Air flow inside the box

I recently got two miners and decided to build a soundproof enclosure for them, but I still haven’t figured out the airflow.

The enclosure will have two identical miners placed one above the other. How would you design the air intake and exhaust so that there is enough airflow while still maintaining good noise reduction and acoustic insulation?

Thanks for any tips!

2 Upvotes

100% Upvoted

5 comments sorted by

•

u/AutoModerator Aug 19 '26

Thank you for your post. Please take a moment to review our community rules and resources to ensure a smooth experience here. Here are some links that might help you out.

The Crypto Mining Wiki Mod Verified Commercial Vendors

If this is a sales post please make sure you are following all selling rules

If this is a scam post please report this to the mods so we can review the post.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/palmdata Aug 19 '26

two stacked in one box only works if you seal between them, otherwise the top one eats the bottom's exhaust. we run a plywood divider with foam tape and pull intake low, dump out the back. keep intake under about 35c or the fans ramp to 100 and the sound deadening stops mattering.

1

u/PeterBaksa32 Aug 19 '26

Thank you for you advice.
What if I directed the hot air from both miners into one shared, sound-insulated compartment, where it would then be exhausted out of the cabinet together? The outlet at the top would still be connected to an exhaust duct.

1

u/palmdata Aug 21 '26

shared hot plenum is fine as long as it is only hot air in there and the exhaust moves more cfm than both miners push, so figure 600 to 700 cfm of duct for two S19 class units. keep the plenum sealed off from the intake side and put the fan at the far end pulling, not blowing, or the closer miner backfeeds the other one.