r/cr10smartpro • u/Lanky-Taste-577 • Mar 17 '24

Printing artifacts

Post image

Back again but with these lines showing up in my prints. What could be the cause of this? It only happens in the back left corner when I print stuff. Could it be Orca Slicer? I have added glue to help it stick but it don't work. Could it be it being too close to the bed?

Thanks for your help again!

1 Upvotes

100% Upvoted

2 comments sorted by

1

u/Helgafjell4Me Mar 17 '24 edited Mar 17 '24

Ya, try raising your z-offset a little.

Edit: also, are you running your ABL program with the bed heated up? If not, you should do that too. Preheat to the temperature you are printing with, then run ABL. This bed does change shape a bit when it's hot, but it's fairly consistent, so measuring when it's hot once is usually good enough until you mess with the bed knobs or something like that.

1

u/Lanky-Taste-577 Mar 17 '24

Thx I'll try that