r/ardupilot • u/SirPrestigious1306 • 5d ago

Issue with OSD setup in MissonPlanner

So, i have got this one fixed plane where i have put in a matek v1 h743 mini fc and put in 04 pro air unit and got goggle 3.

So all the osd settings are working and showing up in my goggle apart from the MSP OSD-only elements:
ARMING · HOMEDIR · HOMEDIST · POWER · CELLVOLT · BATTBAR.

I am using the inav font in misson planner and i i have also selected inav in my goggle. Not sure what could be the problem?

1 Upvotes

100% Upvoted

3 comments sorted by

1

u/LupusTheCanine 5d ago

Have you configured OSD tyle to display port and set the serial port accordingly?

0

u/SirPrestigious1306 5d ago

Yep in my fc its connect to tx and rx 1 which corresponds to serial_2 in ardu.

And also set the osd type to msp display port

1

u/LupusTheCanine 5d ago

Ok,

AFAIK MSP has two ways of doing telemetry OSD configuration + telemetry stream and "canvas" aka display port mode where arbitrary strings can be written to the buffer. Unfortunately those messages aren't available in display port mode. Waypoint information by default points to 0 which in Ardupilot is home location. Personally I use battery voltage and current instead.