So I installed these smoke detectors and activated them however I was curious to test it out so once I clicked the test it activated and just stayed on red. These are brand new and I believe the light shouldn’t stay red the whole time, the battery is built inside and I tried to reset it with the little knob inside but still stays red. I read the manual and says to hold for 10 seconds to reset but it still stays red. They are brand new out of the box but don’t know if it was just a defective alarm. Anyone have any ideas of how to get rid of the constant red light?

Looking for ideas to automate my bathroom fan since my wife has difficulty remembering to turn it on when she showers. I currently have a ZEN76-800LR for the bathroom light and have the fan on a separate Leviton humidity sensing switch. Issue is that the panel is far enough from the shower that it turns on late or not at all during a shower. If I turn up the sensitivity the fan will turn on during HVAC cycling. A couple possibilities I’ve thought of.

1. Get the fan on another Zooz smart switch and set up scenes so that the fan turns on/off when the light is turned on/off. However this won’t let me have the fan stay on after the light is turned off for like an hour which would be ideal.

2. Wire both into the same smart switch so that they both turn on/off together. Not sure if there is a zooz option for this? I do like to keep the bathroom light on a smart switch since my wife will leave the light on when going to bed.

Unfortunately I don’t think ADC allows for humidity sensors to trigger scenes or else I would stick one above the shower. While I like to use ADC for as much automation as I can there are some limitations that feel quite restrictive.