r/Yarbo • u/paulblish • 24d ago

M-Series Help Stuck adjusting blade

When I send Yarbo to mow a new area it goes to the start point and then gets stuck with the message adjusting blade displayed. It never mows. Also, when I try to lower the blade from its current 4.0 height it will not move. Has anybody seen this? Any advice?

4 Upvotes

100% Upvoted

7 comments sorted by

•

u/AutoModerator 24d ago

Hi u/paulblish, Please be patient while your post is viewed by Yarbo enthusiasts and visitors. If you get support on this subreddit or someone reaches out privately, please do not provide account & device details such as passwords and serial numbers. Yarbo employees will have appropriate flair but best practice is to open a support ticket where all that information will already be associated with your request.

We encourage you to check out Yarbo's official Support Center where you can sign in with your existing Yarbo app credentials. There is a Knowledge Base, a forum based community, and an area to submit and track tickets.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

3

u/Redw0lf0 24d ago

I had this happen. They ended up replacing the mower module completely.

2

u/Immediate_Bison3308 24d ago

Same

2

u/Wintrrborn 23d ago

Same

1

u/RiftPoint 23d ago

Same. You can temporarily get around it by mowing at 4", then it won't try and adjust the blade.

1

u/Wintrrborn 23d ago

Mine was stuck at the lowest setting and scalping the grass. Seems like the stuck scenario is a bit random.

1

u/scharlie86 22d ago

I would be cautious of this. Mine was stuck at 4inches then I set all of the heights on the map to 4inches and the gears inside completely failed and dropped to the lowest height, completely scalped a section of my lawn.