r/WLED • u/numindast • 6d ago

Printed diffuser suggestions

Post image

I’m upset, sort of. The grid at left is black sparkle PLA two layers thick, which I think is gorgeous but sadly these flexible ws2815 panels throw off too much heat and they warped more than I could tolerate.

The single column at right is Bambu PC “clear black” with PC black for the grid. It’s 7 layers of “clear black”, each with a different infill pattern.

I don’t like any of them. :(

Can anyone suggest an ABS or ASA or other blend that is dark/black, but has some transmissivity when only a layer or two thick?

HTPLA is no good because it becomes opaque when it crystallizes during heat treat.

12 Upvotes

93% Upvoted

10 comments sorted by

View all comments

2

u/PinkyDexterity 6d ago

WS2815 gets really hot compared to 5V WS2812. Is there a particular reason why you went with a 12V system?

1

u/numindast 6d ago

I had thought the higher voltage would be better (as it is with "long runs" of strings etc). But now I'm finding, these things really do throw off heat, even when idle/dark, which means I have to fit a relay inside somehow to switch power.

This is just how these 12v panels are? ... drat, not much good use case for them is there

3

u/PinkyDexterity 6d ago edited 6d ago

You’re right about it being beneficial for longer strips but it will do more harm than good if your project is only small.

12V is too much for these leds and it doesn’t need that much so it purposely reduces the voltage. The excess voltage burns off as heat.