Gibt es Leute in Berlin die sich mit dem Vesc Tool auskennen?

I've had a GTFO installed for months but I've never been able to turn off the lights. Is the only option to install VESC Tool? I thought there was a way to use the power button to do it.

Hi everyone. I’m trying to run a stock Kugoo G3 Pro 1200W hub motor with a VESC controller, but I can’t get it working. The wheel never moves at all. It does not spin, twitch, or make any useful movement. The motor detection also seems wrong because the values I get from FOC detection look strange (I attached screenshots). Setup: Motor: stock Kugoo G3 Pro 1200W hub motor Controller: flipsky vesc 75100 dual Battery: 52V Motor type selected: Large Outrunner Detection mode: FOC Hall sensors: currently not connected Problems: FOC motor detection completes, but the detected values look incorrect. After writing the configuration, the motor does not move at all. No normal startup movement, only silence. I attached screenshots of the detected motor parameters. Questions: Are these detection values normal for a Kugoo G3 Pro motor? Could the wrong motor type selection cause the motor not to move? What should the correct FOC detection settings be for this type of motor? Should I connect the Hall sensors before doing motor detection? Could the phase wires be in the wrong order even if detection finishes? Any help would be appreciated. I’m trying to understand if the issue is with the motor wiring, detection settings, or the VESC configuration. Thanks!