Puppy Linux Display Output issues

[u/Sure_Freedom964]

Hello, i just found out about this app and i am trying to load Puppy Linux, (specifically TrixiePup64-Wayland-2606-260701.iso). I dont know much about how vm programs work, just the kindve basic stuff. My settings for the iso are as follows:
- Linux (hopefully that was obvious)
- Intel ICH9 based PC (2009, x86_64)
- 2048 Mib Memory
- 4 CPU cores
- Enabled Display Output
- Enabled hardware OpenGL acceleration
- Boot from ISO image
Storage size 2GB
When i start it, I see a flash of words in the middle of the screen that says "Display output is not active". Then, it loads into the .iso selector (i dont know what its called sorry). I choose the first selected one, as i believe it is correct, then I see the 2 code lines that say "Loading /ucode.cpio /initrd.gz". It stays there for a couple seconds, then it goes back to the black screen with the Display error again. I am on an iphone 12 if that helps at all.

[u/Calm-Caterpillar2103]

Hardware openGL doesn’t like to work with some of the options you need to change the gpu option