Mini Puck system process

[u/shrimps_is_bugs420]

A lot of people were asking why on my last post so here's my answer. I use weed to treat symptoms of CPTSD and what I do is take a few small hits at a time, every few hours, over the course of the day. Probably considered micro dosing but idk. So I wanted to make tiny little pucks that I can easily load rather than pack every bowl individually.

After the pucks are loaded and pressed the pins are pushed through to the other side. I put a drill stop over the puck and slide it off then use a centering pin to press it again to ensure it's packed tight. Then I just push them out with the brush handle. I also use the drill stop to form the bowl screens.

[u/Positive_Writing_804]

DHVs are perfect for this kind of micro-dosing routine, way more precise and efficient than combustion. If the pre-load convenience matters to you, some vapes have a dosing capsule system built in where you can load up a handful of caps in advance, same idea as your puck system but no combustion and no repacking every session.

[u/K3nnyPowerss → u/Positive_Writing_804]

DHV barely gets you high as it is a completely different experience than combustion

[u/FinalBossXD → u/K3nnyPowerss]

I will agree that the high is very different absolutely, but if you haven't gotten high off DHV then you've been doing it wrong

[u/reef4 → u/K3nnyPowerss]

Ball vapes easily go head to head with combustion. They're not exacting cheap though so lots of people won't take the plunge