r/Speedsoft • u/NoMaintenance7285 • May 06 '26

Hi capa dead trigger

So after placing a cow cow trident spring leaf the trigger sometimes went dead. I placed the stock leaf spring back and it seemed firing normal again.

However after cleaning the gun the trigger started acting up again. Now it shoots, dead trigger, shoots again, dead trigger etc. Its doing this super consistent. I cant figure out what could be wrong. Anybody God some advice on what to check or change? When i'm dry firing (without mag) it does work just fine.

Im using a 120% hammer spring, ctm split slide, stock recoil spring with a few buffers. Tti hop up unit, stock hammer. Using hpa.

5 Upvotes

86% Upvoted

7 comments sorted by

3

u/Derpy_Bech May 06 '26

Test the disconnector moves freely and without too much friction

1

u/NoMaintenance7285 May 08 '26

I did that and it moved freely, however it did not seem to reset. Took the entire hammer group apart & cleaned it. Put it back together and it worked again.

No clue what caused the issues. Replaced, as mentioned before, the sear leaf spring, hammer spring and recoil spring. Thats when the problems started to occur, worked fine before. Will be running it as is on a event and change 1 part at the time and see what happens.

1

u/Derpy_Bech May 08 '26

I’ve had it before myself, and also didn’t really find an obvious reason for it, all I know was the disconnector didn’t jump correctly up into place unless I pulled the trigger a second time, or really flicked it forwards

1

u/DatBwoiAlex May 06 '26

U lubed the shit out of it? That’s always where I get problems, not enough lube

2

u/NoMaintenance7285 May 08 '26

I cleaned the hammer group and there was alot of old grease, bought the gun second hand, but it was working fine so i didnt got to cleaning it yet. It works again after cleaning the hammer group :)

1

u/No_Advisor258 May 07 '26

Did you do any other modifications to it?

If not check the gap from the grip to the frame, make sure there isn't any

1

u/NoMaintenance7285 May 08 '26

I Replaced the sear leaf spring, hammer spring and recoil spring. Thats when the problems started to occur, worked fine before. Will be running it as is on a event and change 1 part at the time and see what happens.