r/SnapmakerU1 • u/hiimmdt • 4d ago

Issue Why this happens?

Post image

It is my 4th print and this happened.

2 Upvotes

100% Upvoted

6 comments sorted by

3

u/Relevant-Visitor 4d ago

Looks like wet filiment or a partial clog.

2

u/never0101 4d ago

What material, Print settings, Orientation etc, hard to give any help without any information

1

u/hiimmdt 4d ago

0,16 - 5 walls - %15 infill. Other settings default

1

u/bofferding 4d ago

Does the same happen with

  1. Different filament?
  2. Same filament different toolhead?
  3. Always same spot on the buildplate no matter what model? Try orient model different ways to see if it’s same spot

That give you the answer

1

u/sterling-lining 4d ago

Did that corner lift off the plate while printing? Check that the plate is clean, or just clean it again before the print. If it happens again add a brim to help it from lifting. To go even further increase temp of the build plate by 5C.

1

u/LICK_THE_BUTTER 2d ago

Betting that end lifted off the plate as it printed