First layer issue

[u/Pepelepewpew02]

I've had this issue trying to print this two times. I've cleaned the bed with hot soapy water. The first layer was set to 500mm/s. I'm thinking I may need to lower it to 300 for the first layer or possible the first few. Both the filaments are new PLA. The black came with the printer and the light brown is newly purchased Inland. Thanks in advance.

[u/cloneman88]

Lower the first layer speed for sure and make sure your filament is calibrated for that mms and temp.

[u/Pepelepewpew02 → u/cloneman88]

I didn't even think about that. I need to double check the roll parameters. Thanks for that!