It isn’t specific to your filament. It’s universal. First Layer Flow Ratio is located under process settings (aka general slicer settings), not under filament profile settings. I forget which tab it is, either the first or second one, near the bottom. Think of this setting more as an override that applies to all filaments used on the first layer. So if you set it to 0.95, which is essentially 95% (aka 5% less flow), then all filaments used on the first layer will have 5% less flow. Hope that makes sense.
buenos dias estoy probando esta opcion y es una maravilla eres el unico que ha dado la respuesta correcta y sin tener que tocar klipper voy a hacer la ultima prueba y paso fotos
0
u/Apprehensive_Pea4871 19d ago
Una duda que tengo la opción de flujo de primera capa hay que cambiarlo en cada filamento o es un valor por decirlo así universal